2006-3-23 sandblast

シリンダーのサンドブラストに特化した簡易型ボックスでサンドブラストをしてみました。

This time I did sandblasting.

直圧式サンドブラスターです。
サンドブラスト研究に記載されている方法で作りました。
小さい圧力で流量も少なくて、効率よくサンドブラストできます。
これは何にでも使えます。
ちなみに圧は1.5気圧くらいコンプレッサーはたまに動く程度で十分サンドブラストできます。


This is shop made sandblasting apparatus
You can see the datail about it here(japanese only)

This works under low pressure and low flow rate.
It works at 25 to 30psi.
フランジ下とヘッド部分を覆い、軸に固定するためのふたを作りました。


These are covers which are applied on the top and bottom of the cylinder.
シリンダーにセットしました。


Set on the cylinder.
上のセットをギアードモータの軸にセットします。


Those components are set on the shaft of the geared motor.
これをボックスに入れて回転させながら前後に動かしサンドブラストします。回転は一定なので均一に素早くサンドブラストできます。箱の中には手を入れません。外から軸を前後に動かせばOKです。
写真撮影のため窓のサランラップははずしてあります。
左奥に吸引用の掃除機の吸い口がうっすら見えています。
非常にうまくいったので段ボールはやめて次回はちゃんとした箱を作ります。
とりあえず今回は段ボール箱で全てのシリンダーをサンドブラストできました。


In the box, cylinder round in constant speed and can be moved forward and backward by the hand from outside of the box.
Cover glass was taken out to show the detail

The box are made from corrugated carton.
It works very well, I will make wood box next time.
左が切削のみ。右がサンドブラスト仕上げ。
表面積が増え冷却効率も上がっているでしょう。


left: only turning on the lathe

right:after sandblast

Back to Kinner index